Organize your cables with professional desk and cabinet cable-pass through grommets. Cut hole to size specified, and either press or glue into place.

Specifications:

• Hole Size Required: 2.0".
  
• Grommet Insert Width: 1.960" (50mm)
  
• Grommet Lid Width: 2 7/16"
  
• Grommet Depth: 5/8"
  
• Inside Diameter (Approx): 1.75"
  
• Size Tolerances May Vary

Important Installation Note: The Grommets are manufactured to be slightly less that the hole size. For example, if we have a grommet advertised at 2.0 inches (example size ONLY), when measured on a caliper, it will measure at approx. 1.960" inches - or approx .04 inches LESS than the hole size of 2 inches. This difference is by design to allow for the grommet to be inserted into the CUT hole size. These grommets after inserted into a cut hole are intended to move freely. If you need a TIGHT fit, a small amount of glue or silicon may be needed.

Please see technical drawing (Product Manual) below for size and shape details.

• Hole Size Required: 2.0
• Grommet Insert Width: 1.960
• Grommet Lid Width: 2 7/16
• Grommet Depth: 5/8
• Inside Diameter (Approx): 1.75

Hole Size Required: 2.0My Cable Mart